Rockwell Automation 2098-UWCPRG Ultraware Software User Manual - Manual (Page 190)

192 Rockwell Automation Publication 2098-UM001G-EN-P - February 2011
Chapter 4 Configuring the Ultra5000 Drive
To assign a specific input signal, or status, to the selected channel:
1. Click one or more + (plus) signs to open the tree control to the desired
branch.
2. Place a check mark in the box next to the desired input signal, or status.
3. Click OK to display the selected input signal as the channel in the
Oscilloscope window.
To assign no input signal, or status, to the selected channel:
1. Be sure no check marks appear next to any input signal, or status.
2. Click OK.
The word Unassigned appears in the selected Channel in the Oscilloscope
window.
3. Click OK to display Unassigned as the channel in the Oscilloscope
window.