Rockwell Automation 2098-UWCPRG Ultraware Software User Manual - Manual (Page 215)

Rockwell Automation Publication 2098-UM001G-EN-P - February 2011 217
Configuring the Ultra5000 Drive Chapter 4
Understanding the Service
Information Window The Properties window for the Service Information branch of Ultra5000 drives,
firmware revision 1.2 or higher, looks like this.
Use the Service Information window to:
• Set the Drive Type parameter.
• Display and monitor service information about the drive.
• Display the firmware revisions of the drive.
The following parameters can be entered in the window.
Parameter Description
Drive Type The model number of an online drive as assigned at the factory. Off-
line Ultra5000 drives do not have a specific model.
• Invalid: prevents the drive from being enabled.
• 2098-IPD-005
• 2098-IPD-010
• 2098-IPD-020
• 2098-IPD-030
• 2098-IPD-050
• 2098-IPD-100
• 2098-IPD-150
• 2098-IPD-HV030
• 2098-IPD-HV050
• 2098-IPD-HV100
• 2098-IPD-HV150
• 2098-IPD-HV220
Note: the drive uses the selection to:
• decide when to signal an IPM Filter fault, and
• properly scale the feedback from the power stage of the drive. The
output of the velocity regulator stage of the drive is limited by the
selected drive type.