Understanding the oscilloscope window – Rockwell Automation 2098-UWCPRG Ultraware Software User Manual User Manual
Page 276
Advertising
278
Rockwell Automation Publication 2098-UM001G-EN-P - February 2011
Chapter 5 Configuring the Kinetix 3 Drive
Understanding the
Oscilloscope Window
The Properties window for the Oscilloscope looks like this.
Use the Oscilloscope window to trace one of four drive signals by:
•
Configuring the oscilloscope by selecting a the drive signal to trace.
•
executing commands that run the oscilloscope's tracing function
continuously or in response to the configured trigger.
•
monitoring the oscilloscope as it traces the selected drive signal.
Advertising