Rockwell Automation 2098-UWCPRG Ultraware Software User Manual - Manual (Page 280)

282 Rockwell Automation Publication 2098-UM001G-EN-P - February 2011
Chapter 5 Configuring the Kinetix 3 Drive
2. Click OK.
The word Unassigned appears in the selected Channel in the Oscilloscope
window.
Understanding Kinetix 3
Status Displays Status for the Kinetix 3 drive are displayed in the Monitor window. Signals from
oscilloscope channels may be used as data sources for the status table.
Status Description Oscilloscope
Input Trigger
Oscilloscope
Output Trigger Monitor Analog Output
Signal
Fault Detail
Channel
Drive Status
Analog Command -
Velocity Refer to Understanding the
Analog Window on page 237 X X X X X
Analog Command -
Current Refer to Understanding the
Analog Window on page 237 X X X X X
Bus Voltage The current measure of DC Bus
voltage. X X X
Commutation Angle -
Degrees Reports the position within the
motor electrical cycle in
degrees from -180 to 180
degrees. X X X X X
Enabled ON indicates the power stage
of the drive is enabled. As a
precondition, either software
or hardware enable must be
active, and the drive cannot
have any faults. X
Fault Warning Refer to Understanding the
Kinetix 3 Drive Branch on
page 225
.
X
Firmware Version Refer to Understanding the
Service Information Window
on page 297 X
Motor Temperature Reports the percentage of the
Motor Temperature Trip value,
that is based on the motors
continuous current rating,
thermal characteristics, and
time.
The Motor Temperature is an
indication of the level of
utilization of the motor's
current capability. When the
Motor Temperature reaches
100% a Motor Filter fault
occurs. X X X
Current Operating
Mode Refer to Understanding the
Kinetix 3 Drive Branch on
page 225 X