Rockwell Automation SP600 User Manual Version 3.0 - Manual (Page 11)

Contents IX
List of Tables
Table 2.1 – Power Ratings.......................................................................... 2-3
Table 2.2 – Power Ratings.......................................................................... 2-4
Table 2.3 – SP600 AC Drive EN1800-3 EMC Compatibility ..................... 2-18
Table 2.4 – Identification of Drive Connections ........................................ 2-19
Table 2.5 – Standard Kits and Options ..................................................... 2-21
Table 2.6 – Remote OIM Model Number and Instruction
Manual Number ................................................................... 2-21
Table 2.7 – PC-Based Utility Model Number and Instruction
Manual Number ................................................................... 2-22
Table 4.1 – Recommended Shielded Wire ................................................. 4-3
Table 4.2 – Power Terminal Block Specifications....................................... 4-3
Table 4.3 – Recommended Signal and Control Wire.................................. 4-5
Table 4.4 – AC Line Input Fuse Selection Values ................................... 4-10
Table 4.5 – AC Line Input Fuse Selection Values ................................... 4-11
Table 6.1 – Terminal Tightening Torques ................................................... 6-2
Table 6.2 – AC Line Reactors..................................................................... 6-3
Table 6.3 – Power Terminal Descriptions ................................................... 6-6
Table 7.1 – Wiring Signal and Control I/O to the Terminal Block................ 7-3
Table 7.2 – Parameter Configuration for Figure 7.1 Wiring Example ......... 7-8
Table 9.1 – Quickstart Parameters ............................................................. 9-3
Table 11.1 – Parameter List...................................................................... 11-2
Table 11.2 – Default Values for Preset Speeds 1-7................................ 11-25
Table 11.3 – Sleep-Wake Mode ............................................................. 11-47
Table 11.4 – Dynamic User Set Mode .................................................... 11-56
Table 11.5 – Analog Output Scaling ....................................................... 11-82
Table 11.6 – Speed Select Inputs........................................................... 11-84
Table 11.7 – Default Values for Parameters 361-366............................. 11-84
Table 11.8 – Drive Response to Jog Forward and Jog Reverse Inputs . 11-86
Table 11.9 – Effect of Speed Select Input State on Selected Reference 11-88
Table 12.1 – Precharge Board LED Indicators ......................................... 12-3
Table 12.2 – Ready LED Status Definitions.............................................. 12-4
Table 12.3 – Types of Alarms ................................................................... 12-5
Table 12.4 – Alarm Descriptions............................................................... 12-6
Table 12.5 – Alarm Names Cross-Referenced by Alarm Numbers .......... 12-8
Table 12.6 – Fault Types .......................................................................... 12-9
Table 12.7 – Fault Descriptions and Corrective Actions ......................... 12-12
Table 12.8 – Fault Names Cross-Referenced by Fault Number............. 12-18
Table 12.9 – Drive Does Not Start From Terminal Block Logic .............. 12-19