Rockwell Automation SP600 User Manual Version 3.0 - Manual (Page 233)

Using the LCD OIM B-1
A
PPENDIX
B
Using the LCD OIM
The LCD Operator Interface Module (OIM) is a keypad/display that
enables you to program, monitor, and control the drive.
B.1 Connections
The LCD OIM can be used in the following ways:
Drive mounted - The OIM connects directly to the drive using DPI
port 1.
Hand-held - A cable (RECBL-LCD) must be used to convert the
OIM for hand-held use. The maximum cable length is 32 feet using
extender cables. Connect the cable to either DPI port 2 or 3.
Remote mounted - A NEMA 4 remote mount OIM is available. The
maximum cable length is 32 feet using extender cables. Connect
the cable to either DPI port 2 or 3.
See figure 2.2 in chapter 2 for the connection points on the drive.
Figure B.1 – SP600 LCD OIM
text
F1
ESC/
PROG
JOG
F2 F3 F4
o I
Refer to
section B.3
for the
display
description.
Refer to
section B.4
for the key
descriptions.