Rockwell Automation SP600 User Manual Version 3.0 - Manual (Page 39)

Mounting the Drive 3-3
Frames Jumper Component No. Action
2-4 PEA Common Mode
Capacitors
1 Remove jumper located above the
Power Terminal Block.
PEB MOV’s 2 Same as above.
5
6
Wire Common Mode
Capacitors
MOV’s
Input Filter
Capacitors
3
4
Remove the I/O Cassette. The
yellow/green jumper is located on the
back of the chassis in the area
shown. Disconnect, insulate and
secure the wire to guard against
unintentional contact with chassis or
components.
Wire Common Mode
Capacitors
MOV’s
Input Filter
Capacitors
Remove the wire guard from the
Power Terminal Block. Disconnect
the three green/yellow wires from the
two “PE” terminals shown. Insulate
and secure the wires to guard
against unintentional contact chassis
or components.
Figure 3.1 – Typical Jumper Locations
BR1 BR2 DC+ DC- U/T1 V/T2 W/T3
SHLD SHLD
PE R/L1 S/L2 T/L3
PE 2
MOV-PE JMPR
PE 1
AUX IN+ AUX OUT–
75C Cu Wire 6 AWG [10MM 2 ] Max. 12 IN. LBS.
1.4 N-M } TORQUE
WIRE
STRIP
CONTROL POWER
PE 4 PE 3
DC FILTER CAP-PE JMPR
Frame 2
Frame 5
BR1 BR2 DC+ DC- U/T1 V/T2 W/T3 R/L1 S/L2 T/L3
PE B
PE A
75C Cu Wire 3 AWG [25MM 2 ] Max. 16 IN. LBS.
1.8 N-M } TORQUE
WIRE
STRIP
CONTROL POWER
AUX IN + –
SHLD
SHLD
PE
75C Cu Wire 6 AWG [10MM2] Max.
BR1 BR2
12 IN. LBS.
1.4 N-M } TORQUE
WIRE RANGE: 14-1/0 AWG (2.5-35 MM2)
TORQUE: 32 IN-LB (3.6 N-M)
STRIP LENGTH: 0.67 IN (17 MM)
USE 75
° C CU WIRE ONLY
POWER TERMINAL RATINGS
WIRE RANGE: 6-1/0 AWG (16-35 MM2)
TORQUE: 44 IN-LB (5 N-M)
STRIP LENGTH: 0.83 IN (21 MM) GROUND TERMINAL RATINGS (PE)
300 VDC EXT PWR SPLY TERM (PS+, PS-) WIRE RANGE: 22-10 AWG (0.5-4 MM2)
TORQUE: 5.3 IN-LB (0.6 N-M)
STRIP LENGTH: 0.35 IN (9 MM)
17
21 INPUT AC OUTPUT
Optional Communications Module
9
Frames 3 & 4