Rockwell Automation SP600 User Manual Version 3.0 - Manual (Page 33)

About the Drive 2-19
2.5 Drive Connections
Figure 2.4 shows the locations of the drive terminal blocks and
connectors used to set up and operate the drive. Table 2.3 identifies
the drive connections shown with the corresponding number in
figure 2.2.
Table 2.4 – Identification of Drive Connections
No. Connector Description
Power
Terminal Block Connections for input and output power
wiring.
Signal and I/O
Terminal Block Connections for signal and I/O wiring.
Important: The I/O board may be 24 VDC or
115 VAC. Check the model
number on the drive nameplate.
DPI Port 1 OIM connection.
DPI Port 2 Connection for remote OIM or RECOMM-232
serial interface.
DPI Port 5 Connection for optional communications
module.