Rockwell Automation SP600 User Manual Version 3.0 - Manual (Page 35)

About the Drive 2-21
2.6 Drive Communication Options
The flat-ribbon cable connector (labeled in figure 2.2) is a
parallel bus connection port that provides a means of attaching
optional communication modules such as the DeviceNet
Communication module to the SP600 AC drive.
Refer to the appropriate board instruction manual for more
information. See table 2.5 for a list of available communication
options.
2.7 Remote Operator Interface
The SP600 drive can be controlled and monitored using a remote
LCD OIM (Operator Interface Module).
2.7.1 Connecting the Remote OIM or VS Utilities to
the Drive
NEMA 1 Drives
The remote OIM connects to DPI port 2 at the bottom of the drive
frame (labeled in figure 2.2). Note that you must change the
appropriate parameters (89 and 90) to enable control from the
remote keypad.
Table 2.5 – Standard Kits and Options
Description Model Number
Instruction
Manual
DeviceNet Communication Module RECOMM-DNET D2-3478
Profibus Communication Module RECOMM-PBUS D2-3479
Interbus Communication Module RECOMM-IBUS D2-3480
ControlNet Communication Module RECOMM-CNET D2-3497
Ethernet/IP Communication Module RECOMM-ENET D2-3510
Modbus Communication Module RECOMM-H485 VT-1001-2
RS485 DF1 Communication Module RECOMM-485 D2-3514
Table 2.6 – Remote OIM Model Number and Instruction Manual Number
Description Model Number
Instruction
Manual
Remote NEMA 4X LCD OIM RE4LCD-PNL D2-3490
Small Remote NEMA 4X LCD OIM RE4ALCD D2-3525