Rockwell Automation SP600 User Manual Version 3.0 - Manual (Page 62)

5-2 SP600 AC Drive User Manual
!
ATTENTION: Unused wires in conduit must be grounded at
both ends to avoid a possible shock hazard caused by induced
voltages. Also, if a drive sharing a conduit is being serviced or
installed, all drives using this conduit should be disabled to
eliminate the possible shock hazard from cross-coupled motor
leads. Failure to observe these precautions could result in
bodily injury.
Figure 5.1 – Wire Routing and Terminal Block Locations (Frame 2 Shown)
BR1 B
SHLD SHLD
V/T2 W/T3 PE R/L1 S/L2 T/L3
AUX IN+ AUX OUT–
Optional
Communications
Module
75C Cu Wire 6 AWG [10MM 2 ] Max. 12 IN. LBS.
1.4 N-M } TORQUE
WIRE
STRIP
CONTROL POWER
Signal and Control
Terminal Block
Power
Terminal Block
I/O and Signal Wiring
Input Power Wiring
Motor Wiring
Terminal
Shield
(Frame 2 shown)