Rockwell Automation SP600 User Manual Version 3.0 - Manual (Page 67)

Installing Power Wiring 6-1
C
HAPTER
6
Installing Power Wiring
This chapter provides instructions on output wiring to the motor and
installing AC input power wiring. Refer to figure 6.2 at the end of this
chapter for a description of the power terminal block.
6.1 Opening the Cover
Follow these steps to open the drive cover.
Step 1. Locate the slot in the upper left hand corner of the drive
(see figure 6.1).
Step 2. Slide the locking tab up and swing the door open.
!
ATTENTION: The user is responsible for conforming with all
applicable local and national codes. Failure to observe this
precaution could result in damage to, or destruction of, the
equipment.
!
ATTENTION: DC bus capacitors retain hazardous voltages
after input power has been removed. After disconnecting input
power, wait five minutes for the DC bus capacitors to discharge
and then check the voltage with a voltmeter to ensure the DC
bus capacitors are discharged before touching any internal
components. Failure to observe this precaution could result in
severe bodily injury or loss of life.
Figure 6.1 – Opening the Drive Cover
PWR
RDY
PWR PWR
RD RDY