Rockwell Automation SP600 User Manual Version 3.0 - Manual (Page 242)

B-10 SP600 AC Drive User Manual
Note that changing the value of the OIM reference does not affect
the value of any other port reference.
The value of the OIM reference is saved through a power cycle if
parameter 192 (Save OIM Ref) is set to save at power down.
B.8.2 Customizing the Process Display Screen
To customize the process display screen, select Monitor from the
Display menu. See figure B.8.
B.8.3 Customizing the Function Keys
The function keys (F1, F2, F3, and F4, also called F-Keys) on the
OIM can be customized to perform several pre-configured functions
when the process display screen is active.
Up to eight function keys can be configured. Pressing while
the display screen is active toggles between each set of four
functions.
As shipped from the factory, the F1 key is configured for the
Auto/Manual selection function and the F4 key is configured for the
Clear Fault Queue function.
To assign a function to an F-Key, select the Display icon from the
Main Menu as shown in figures B.9 and B.10.
The F-Key definitions are the same for all OIMs connected to the
drive, regardless of the port used.
Figure B.8 – Customizing the Process Display Screen
Monitor Lang
P0: SP600
>> Auto Stopped
Main Menu
Display
Display:
Language
Function Keys
Monitor
Dispy: Dspy Ln#
Scale:
Text:
Par: #
Param Scale Text Save
Use
to select display line
1, 2, 3, 4, 5, or 6.
Press F4 to save
Adjust scale
Accept scaling value
Scroll through parameter
numbers
Select parameter
Move through label text
Move through letters
and symbols
F3 Toggle between upper
and lower case