Rockwell Automation SP600 User Manual Version 3.0 - Manual (Page 171)

Parameter Descriptions 11-69
Elapsed hours since drive power up. This value will rollover to 0
after the drive has been powered on for more than the maximum
value shown.
Selects conditions that will initiate a drive alarm.
Refer to chapter 12, Troubleshooting the Drive, for alarm definitions.
242 Power Up Marker
Range: 0.0000 to 4,294,967.2925 Hr [0.0001 Hr]
Default: Read Only
Access: 2 Path: Utility>Faults
See also: 244, 246, 248, 250
32
259 Alarm Config 1
Range: See figure 11.30
Default: See figure 11.30
Access: 2 Path: Utility>Alarms
See also:
Figure 11.30 – Alarm Config 1 (259)
1 1 x 1 1 1 x 1 1 1 1 x x x x x
10 0 1 2 3 4 5 6 7 8 9 11 12 13 14 15
1 =Enabled
0 =Disabled
x =Reserved
Bit #
Factory Default Bit Values
Prechrg Actv UnderV
oltage
Po
w
er Loss
Anlg in Loss IntDBRes OH Dr
v OL Lvl 1
Dr
v OL Lvl 2
Decel inhibit W
aking
Nibble 1 Nibble 2 Nibble 3 Nibble 4