Rockwell Automation SP600 User Manual Version 3.0 - Manual (Page 202)

12-6 SP600 AC Drive User Manual
The alarm queue can be cleared using the OIM by selecting “Clr
Alarm Queue”, or by using a PC software tool.
12.4.2 Alarm Descriptions
Table 12.4 – Alarm Descriptions
Alarm Ty
p
e
Description
Analog In
Loss An analog input is configured for alarm on signal loss and
signal loss has occurred.
Bipolar
Conflict Parameter 190 (Direction Mode) is set to Bipolar or
Reverse Dis and one of more of the following digital input
functions is configured: Fwd/Rev or Run Fwd. Note that
the default is Reverse Dis.
Decel
Inhibit The drive is being inhibited from decelerating.
Dig In
ConflictA Digital input functions are in conflict. Combinations
marked with a
will cause an alarm.
Dig In
ConflictB Digital input functions are in conflict. Combinations
marked with a
will cause an alarm.
Dig In
ConflictC More than one physical input has been configured to the
same input function. Multiple configurations are not
allowed for the following input functions:
DigIn Bad
Value Unsupported function selected in Digital In”x” Sel
parameters (361-366).
Acc2 /
Dec2
Accel 2 Decel 2 Fwd / Rev
Acc2 /
Dec2
Accel 2
Decel 2
Fwd / Rev
Start Stop–CF Run Run Fwd Fwd/Rev
Start
Stop–CF
Run
Run Fwd
Fwd / Rev
Forward/Reverse Run Bus Regulation Mode B Jog Reverse
Speed Select 1 Stop Mode B Acc2 / Dec2 UserSetBit0
Speed Select 2 OIM Control Accel 2 UserSetBit1
Speed Select 3 Stop Mode B Decel 2
Run Forward Run Reverse Jog Speed