Rockwell Automation SP600 User Manual Version 3.0 - Manual (Page 2)

©2004 Rockwell Automation. All rights reserved.
The information in this manual is subject to change without notice.
Throughout this manual, the following notes are used to alert you to safety
considerations:
Important: Identifies information that is critical for successful application and
understanding of the product.
The thick black bar shown on the outside margin of this page will be used
throughout this instruction manual to signify new or revised text or figures.
!
ATTENTION: Identifies information about practices or
circumstances that can lead to personal injury or death,
property damage, or economic loss.
ControlNet is a trademark of ControlNet International Ltd.
DeviceNet is a trademark of Open DeviceNet Vendor Association.
SP600, VS Utilities, and Reliance are trademarks of Rockwell Automation.
!
ATTENTION: Only qualified personnel familiar with the
construction and operation of this equipment and the hazards
involved should install, adjust, operate, or service this
equipment. Read and understand this document in its entirety
before proceeding. Failure to observe this precaution could
result in severe bodily injury or loss of life.
ATTENTION: DC bus capacitors retain hazardous voltages
after input power has been removed. After disconnecting input
power, wait five minutes for the DC bus capacitors to discharge
and then check the voltage with a voltmeter to ensure the DC
bus capacitors are discharged before touching any internal
components. Failure to observe this precaution could result in
severe bodily injury or loss of life.
ATTENTION: The drive can operate at and maintain zero
speed. The user is responsible for assuring safe conditions for
operating personnel by providing suitable guards, audible or
visual alarms, or other devices to indicate that the drive is
operating, or may operate, at or near zero speed. Failure to
observe this precaution could result in severe bodily injury or
loss or life.
ATTENTION: The drive contains ESD- (Electrostatic
Discharge) sensitive parts and assemblies. Static control
precautions are required when installing, testing, servicing, or
repairing the drive. Erratic machine operation and damage to,
or destruction of, equipment can result if this procedure is not
followed. Failure to observe this precaution can result in bodily
injury.
ATTENTION: The user must provide an external, hardwired
emergency stop circuit outside of the drive circuitry. This
circuitry must disable the system in case of improper
operation. Uncontrolled machine operation may result if this
procedure is not followed. Failure to observe this precaution
could result in bodily injury.
ATTENTION: The user is responsible for conforming with all
applicable local and national codes. Failure to observe this
precaution could result in damage to, or destruction of, the
equipment.
Trademarks not belonging to Rockwell Automation are property of their
respective companies.