Rockwell Automation SP600 User Manual Version 3.0 - Manual (Page 207)

Troubleshooting the Drive 12-11
12.5.2 Clearing Faults
A fault condition can be cleared by the following:
Step 1. Press or any F-Key to acknowledge the fault and
remove the fault pop-up from the LCD OIM screen.
Step 2. Address the condition that caused the fault. The cause must
be corrected before the fault can be cleared.
Step 3. After corrective action has been taken, clear the fault using
one of the following:
• Setting Fault Clear (240) to Clear Faults (1).
• Press F1 (Cflt) from the fault queue screen.
• Issuing a Stop-Clear Faults command from the control
source.
Resetting faults will clear the faulted status indication. If any fault
condition still exists, the fault will be latched, and another entry
made in the fault queue.
Note that performing a fault reset does not clear the fault queue.
Clearing the fault queue is a separate action. See the Fault Clear
(240) parameter description.
ESC/
PROG