Rockwell Automation SP600 User Manual Version 3.0 - Manual (Page 142)

11-40 SP600 AC Drive User Manual
The DC braking voltage used in this function is created by a PWM
algorithm and may not generate the smooth holding force needed
for some applications.
Sets the amount of time DC brake current is “injected” into the
motor.
Sets the responsiveness of the bus regulator. Adjust the value to
improve the performance of the bus regulator to prevent nuisance
overvoltage faults.
!
ATTENTION: If a hazard of injury due to movement
of equipment or material exists, an auxiliary
mechanical braking device must be used to stop the
motor. Failure to observe this precaution could result
in severe bodily injury or loss of life.
ATTENTION: This feature should not be used with
synchronous or permanent magnet motors. Motors
may be demagnetized during braking. Failure to
observe this precaution could result in damage to,
or destruction of, equipment.
159 DC Brake Time
Range: 0.0 to 90.0 Sec [0.1 Sec]
Default: 0.0 Sec
Access: 1 Path: Dynamic Control>Stop/Brake Modes
See also: 155 - 158
160 Bus Reg Ki
Range: 0 to 5000 [1]
Default: 450
Access: 2 Path: Dynamic Control>Stop/Brake Modes
See also: 161, 162