Rockwell Automation SP600 User Manual Version 3.0 - Manual (Page 4)

II SP600 AC Drive User Manual
2.6 Drive Communication Options ..................................... 2-21
2.7 Remote Operator Interface .......................................... 2-21
2.7.1 Connecting the Remote OIM or VS Utilities
to the Drive ................................................................... 2-21
2.8 PC-Based Utility........................................................... 2-22
Chapter 3 Mounting the Drive
3.1 General Requirements for the Installation Site .............. 3-2
3.1.1 Verifying Power Module AC Input Ratings Match
Available Power................................................... 3-2
3.1.1.1 Unbalanced or Ungrounded Distribution
Systems ................................................ 3-2
3.1.1.2 Input Power Conditioning...................... 3-4
3.1.1.3 AC Input Phase Selection (60HP and
Larger) .................................................. 3-4
3.1.1.4 Selecting/Verifying Fan Voltage (60HP and
Larger) .................................................. 3-4
3.1.2 Making Sure Environmental Conditions are Met . 3-5
3.1.3 Minimum Mounting Clearances ........................... 3-6
3.1.4 Drive Dimensions and Weights............................ 3-7
3.2 Mounting the Drive....................................................... 3-11
3.2.1 Verifying the Drive’s Watts Loss Rating............. 3-11
Chapter 4 Wiring Requirements for the Drive
4.1 Power Wiring.................................................................. 4-1
4.1.1 Power Wire Sizes ................................................ 4-3
4.1.2 Using Input/Output Contactors ............................ 4-4
4.2 Control and Signal Wire Sizes ....................................... 4-5
4.3 Recommended Motor Lead Lengths.............................. 4-5
4.3.1 Reflected Wave Compensation ........................... 4-6
4.4 Selecting Input Line Branch Circuit Protection............... 4-9
4.5 Verifying Power Module Output Current Rating
is Greater than Motor Full Load Amps........................... 4-9
Chapter 5 Finding Wire-Routing Locations and Grounding
5.1 Routing Input, Motor Output, Ground, and Control Wiring
for the Drive ................................................................... 5-1
5.2 Grounding the Drive....................................................... 5-4
Chapter 6 Installing Power Wiring
6.1 Opening the Cover......................................................... 6-1
6.2 Installing Output Power Wiring....................................... 6-2
6.3 Installing Input Wiring..................................................... 6-3
6.3.1 Installing an Optional Transformer and Reactor .. 6-3
6.3.2 Installing Fuses for Branch Circuit Protection...... 6-4
6.3.3 Installing the Required Input Disconnect ............. 6-4