Rockwell Automation SP600 User Manual Version 3.0 - Manual (Page 7)

Contents V
List of Figures
Figure 2.1 – Identifying the Drive by Model Number................................... 2-2
Figure 2.2 – Normal Mode Operation ....................................................... 2-14
Figure 2.3 – Dynamic Mode Operation ..................................................... 2-16
Figure 2.4 – Drive Connections ................................................................ 2-20
Figure 3.1 – Typical Jumper Locations ...................................................... 3-3
Figure 3.2 – Selecting Input Phase and Fan Voltage (60HP and Larger)... 3-5
Figure 3.3 – Minimum Mounting Clearances .............................................. 3-6
Figure 3.4 – Panel-Mount Drive Dimensions - Frames 2 and 3.................. 3-7
Figure 3.5 – Panel Mount Drive Dimensions - Frame 4.............................. 3-8
Figure 3.6 – Panel-Mount Drive Dimensions - Frame 5.............................. 3-9
Figure 3.7 – Panel-Mount Drive Dimensions - Frame 6............................ 3-10
Figure 4.1 – How to Calculate Typical Motor Lead Lengths ....................... 4-6
Figure 4.2 – Inverter and Motor Line-to-line Voltages................................. 4-7
Figure 4.3 – Motor Overvoltage as a Function of Cable Length ................. 4-8
Figure 5.1 – Wire Routing and Terminal Block Locations
(Frame 2 Shown) .................................................................. 5-2
Figure 5.2 – Wire Routing and Terminal Block Locations
(Frame 5 Shown) .................................................................. 5-3
Figure 5.3 – Typical Grounding................................................................... 5-4
Figure 5.4 – Single-Point Grounding/Panel Layout..................................... 5-5
Figure 6.1 – Opening the Drive Cover ........................................................ 6-1
Figure 6.2 – Power Terminal Block............................................................. 6-5
Figure 7.1 – Typical Wiring Diagram........................................................... 7-7
Figure 7.2 – Wiring Diagram - Default Drive Configuration......................... 7-9
Figure 7.3 – Speed Reference Control Flowchart..................................... 7-11
Figure 7.4 – Speed Reference Selection .................................................. 7-13
Figure 9.1 – Accessing the Start-Up Routines............................................ 9-2
Figure 9.2 – Start-Up Menu ........................................................................ 9-2
Figure 9.3 – Start/Stop Control using the Local OIM .................................. 9-5
Figure 9.4 – Two-Wire and Three-Wire Start/Stop Control......................... 9-5
Figure 9.5 – Analog Speed Reference........................................................ 9-6
Figure 10.1 – Example of Parameter Organization................................... 10-2
Figure 10.2 – Accessing the Parameters Using the LCD OIM.................. 10-3
Figure 10.3 – Selecting the Parameter Access Level ............................... 10-4
Figure 10.4 – Setting the Access Level Password.................................... 10-5
Figure 10.5 – Setting the Write-Protect Password.................................... 10-6