Rockwell Automation SP600 User Manual Version 3.0 - Manual (Page 244)

B-12 SP600 AC Drive User Manual
Auto/Manual: Toggles between Auto and Manual reference control.
The text above the function key will change to indicate the
command that will be issued when the key is pressed.
View Fault Queue: Displays the Fault Queue screen (see chapter
12). Press
to return to the process display screen.
Next: Toggles to next set of three process display variables.
B.8.3.1 Customizing the Function Key Label Text
You can customize the text for each function key label (up to five
characters). See figure B.10.
!
ATTENTION: When switching from Auto to Manual
or Manual to Auto, the drive will ramp to the reference
level provided by the new source at the rate specified
in Accel Time 1 (140), Decel Time 1 (142), Accel
Time 2 (141), or Decel Time 2 (143). Be aware that
an abrupt speed change may occur depending upon
the new reference level and rate specified in these
parameters. Failure to observe this precaution could
result in bodily injury.
ESC/
PROG
Figure B.10 – Customizing the Function Key Label Text
Function List:
Load User Set 1
Load User Set 2
Undefined
Do You Wish to
Rename Function
States Text For:
Load User Set 1
Yes No
Function List
F2: Undefined
F3: Undefined
F1: Load User Set 1
ClrFK
Name State Text:
FKey Text
Luse A
A BCDEFGHIJKLM
Next
F1
F2
OIM will use default
F-Key label Luse1
Function List
F2: Undefined
F3: Undefined
F1: Load User Set 1
ClrFK
F4
OIM will use custom
F-Key label LuseA
Move through label text
Move through letters and
symbols
P0: SP600
Auto Stopped
Fltq
0.00 Volts
Amps
Hz
0.00
0.00
Luse1
P0: SP600
Auto Stopped
Fltq
0.00 Volts
Amps
Hz
0.00
0.00
LuseA
A->a Save
F3
Esc or timeout to
Process Display
screen
Esc or timeout to
Process Display
screen
From figure
B.9
Toggle between upper
and lower case
>>
>>