Rockwell Automation Liqui-Flo DBT Reach Drive - Manual (Page 23)

Installation/Wiring 2-17
2.5.7.1 Connections
Important: A motor temperature sensor (RTD, NTC, or thermocouple) should be
considered equivalent to a motor thermostat and wired with the same
considerations. Motor thermostat contacts are generally not isolated from
the drive/controller digital inputs. Therefore, the sensor inputs will not be
isolated on the RTD board.
2.5.7.2 Hardware
The hardware consists of a single PC board with two wired connectors, one for
temperature sensors and the second for power and I/O signals.
Figure 2.9 – RTD Board Connections
1 2 3 1 2 3
S1 S2 J3 - I/O J2 - RTD Inputs J2
13
1 12
24
Mode
Time
Gain
1 6
7 12
Table 2.8 – J2 RTD Board I/O Function
Position I/O Function
1 +24V COM
2 LOUT1 COM
3 LOUT2 COM
4 LOUT3 COM
5 LIN COM
6 AOUT COM
7 +24VDC
8 LOUT1 NO
9 LOUT2 NO
10 LOUT3 NO
11 LIN
12 AOUT