Rockwell Automation Liqui-Flo DBT Reach Drive - Manual (Page 31)

Parameter Descriptions 3-5
This parameter displays the value present at the drive’s PTC input terminals. When a
motor is provided with a PTC (positive temperature coefficient) thermal sensor, it can
be connected to terminals 10 and 23.
Displays the unfiltered value of the actual motor speed based on either the measured
encoder feedback or on an estimation when an encoder is not present.
The value of commanded speed after Accel/Decel and S-Curve are applied.
The summed value of ramped speed, process PI and droop. When FVC Vector mode
is selected, droop will not be added
18 PTC HW Value
Range: 0.00 to 5.00 Volts [0.01 Volts]
Default: Read Only
Access: 2 Path: Monitor>Metering
See also:
21 Spd Fdbk No Filt
Range:
Default: Read Only
Access: 2 Path: Monitor>Metering
See also:
22 Ramped Speed
Range: +/- 400.0 Hz or +/- 24,000.0 RPM [0.1 Hz or 0.1 RPM]
Default: Read Only
Access: 1 Path: Monitor>Metering
See also: 79
23 Speed Reference
Range: +/- 400.0 Hz or +/- 24,000.0 RPM [0.1 Hz or 0.1 RPM]
Default: Read Only
Access: 0 Path: Monitor>Metering
See also: 79