Rockwell Automation Liqui-Flo DBT Reach Drive - Manual (Page 53)

Parameter Descriptions 3-27
Specifies which input signal is being used as a trim input. The trim is an input signal
that is added to the selected speed reference. If an analog input is used as the trim
signal, two scaling parameters [Trim Hi (119) and Trim Lo (120)] are provided.
Specifies which speed references are to be trimmed.
117 Trim In Select
Range: 0 = Setpoint
1 = Analog In 1
2 = Analog In 2
3-6 = Reserved
7 = Pulse In
8 = Encoder
9 = MOP Level
10 = Reserved
11 = Preset Spd 1
12 = Preset Spd 2
13 = Preset Spd 3
14 = Preset Spd 4
15 = Preset Spd 5
16 = Preset Spd 6
17 = Preset Spd 7
18 = Local HIM
19 = DPI Port 2
20 = DPI Port 3
21 = DPI Port 4
22 = Network
23-24 = Reserved
25 = Scale Block 1
26 = Scale Block 2
27 = Scale Block 3
28 = Scale Block 4
Default: 1 = Analog In 1
Access: 2 Path: Speed Command>Speed Trim
See also: 90, 93
118 Trim Out Select
Range: See figure 3.4
Default: See figure 3.4
Access: 2 Path: Speed Command>Speed Trim
See also: 117, 119, 120