H3C Technologies H3C Intelligent Management Center User Manual
Page 882
868
•
MAC Address/Mask: Allows you to enter a specific MAC address and mask for which you want to
either permit or deny traffic for.
A valid MAC address format for IMC consists of three sets of four hexadecimal characters
separated by a dash, "-". For example,
0014-2ad9-05f7
would be a valid entry for a MAC address in IMC.
Similarly, the format for a MAC address mask consists of three sets of four hexadecimal characters
separated by a dash, "-". For example,
ffff-ffff-ffff
would be a valid entry for a MAC address mask in IMC.
The MAC address and its mask must be separated by a forward slash, "/".
A valid entry for a MAC Address/Mask would be
0014-2ad9-05f7/ffff-ffff-ffff
17.
Select the destination MAC address option you want to use by clicking the radio button to the
left of the desired option in the Destination MAC Address section of the Configure Rule – Add Rule
page.
This option specifies where the pattern matching occurs in this rule. In this case, the pattern
matching is applied to the source MAC address.
•
All: Allows you to permit or deny traffic for all MAC addresses.
•
MAC Address/Mask: Allows you to identify a specific MAC address and its mask for which you
want to either permit or deny traffic.
A valid MAC address format for IMC consists of three sets of four hexadecimal characters
separated by a dash, "-". For example,
0014-2ad9-05f7
would be a valid entry for a MAC address in IMC.
Similarly, the format for a MAC address mask consists of three sets of four hexadecimal characters
separated by a dash, "-". For example,
ffff-ffff-ffff
would be a valid entry for a MAC address mask in IMC.
The MAC address and its mask must be separated by a forward slash, "/".
A valid entry for a MAC Address/Mask would be
0014-2ad9-05f7/ffff-ffff-ffff
18.
Select the 802.1 priority you want to apply to this ACL rule from the 802.1 Priority list.
19.
Select the Layer 2 encapsulation type you want to apply to this ACL rule from the Encapsulation
Type list.
20.
Enter the Source VLAN ID by entering it in the Source VLAN ID field.
This field cannot contain question marks or blank spaces.
21.
Select the Layer 2 frame type from the Based Frame Type list.
22.
If you selected Ethernet Frame or 802.2 Ethernet Frame in the Base Frame Type list, you must
specify a code in the Code field.
A valid entry for this field includes any four character hexadecimal value.
23.
If you selected Ethernet Frame or 802.2 Ethernet Frame in the Base Frame Type list, you must also
specify a mask in the Mask field.