LEICA Q3 Digital Camera - Manual (Page 241)

FAQ 241
Menus and displays
Electronic viewfinder is dark EVF brightness is set too low Set the EVF brightness
Display language is not English - Select English in the Language menu
Electronic viewfinder is dark Switchover between EVF and LCD incorrectly set Select a suitable setting
Viewfinder is out of focus Check the diopter setting and adjust as needed
The LCD panel is to dark or too bright/not
clear
The brightness setting is incorrect Adjust the display brightness
Viewing angle is too small View the LCD panel at a perpendicular angle
Brightness sensor is blocked Make sure that the brightness sensor is not blocked
Favorites menu does not appear The favorites menu is empty Add at least one function
Live View stops suddenly or doesn't start The camera is hot due to high ambient temperature,
extended Live View operation, extended video shooting or
continuous shooting
Allow camera to cool down
The brightness in Live View mode is not the
same as in the images
The brightness settings for the LCD panel have no
influence over the exposures
Adjust the brightness settings as needed
Exposure preview is deactivated Activate the function
The number of remaining shots does not count
down after shooting
The image requires only very little memory space This is not a fault; the number of remaining shots is
calculated as approximations
Shooting
Image noise appears on the LCD panel/in the
viewfinder when the shutter button is pressed
to the first pressure point
The gain is increased to aid image composition if the
object is insufficiently lit with reduced lens aperture
Not a fault – image quality will not be impacted
LCD panel/viewfinder deactivates after a very
short time
Power Save settings are activated Change the settings as needed
The display switches off after shooting/the
LCD panel goes dark after shooting
Flash loads after shooting, LCD panel deactivates during
load time
Wait until the flash is charged
Flash won't fire The flash cannot be used with the current settings Refer to the list of flash function-compatible settings
Battery is depleted Charge or replace the battery
Pressing the shutter button while flash is still loading Wait until the flash is loaded
Electronic shutter function is selected Change the setting
Automatic bracketing or continuous shooting is activated Change the setting
The flash does not fully illuminate the object Object is outside the flash range Move object into flash range
Flash is covered Make sure the flash unit is not covered by your finger or
some object