LEICA Q3 Digital Camera - Manual (Page 243)

FAQ 243
Camera does not focus Desired object part is too close to the camera Select Macro mode
Desired object part is very far away Exit Macro mode
Object not suitable for AF Use Focus lock or select manual focus
AF frame is framed in red with activated AF;
images out of focus
Focusing was unsuccessful Try to focus again
No AF frame selectable Focus ring not in AF position Turn the focus ring to the AF position
Automatic Metering Field Control or Face Detection in AF
Mode is selected
Select other control mode
One of the scene modes is currently active Select the P-A-S-M setting under Scene Mode
Image review is activated Deactivate image review
Camera is in Standby mode Press the shutter button to the first pressure point
AF assist lamp does not light up Camera is in video shooting mode Change the mode
Function is deactivated Activate AF
Video recording
No video is recorded The camera is overheated and the function was
temporarily disabled to protect the camera
Allow camera to cool down
Video shooting stops Maximum length of individual video sequence was reached
The memory card's write speed is too low for the selected
video resolution/compression
Insert another memory card or change the storage method
L-Log is not selectable in video mode A 10 bit format was not selected as the video format Switch to 10 bit format or MOV in video format
Review and photo management
Selected images cannot be deleted Some of the selected images are write protected Remove write protection (using the device with which the
file was originally set to write protected)
File numbering does not start at 1 The memory card contains previously stored images See section “Data Management”
The time and date settings are incorrect or are
not displayed
The camera has not been in use for an extended period of
time (the battery was removed)
Insert a charged battery and configure the correct settings
The time and date stamp on images are
incorrect
Time settings are incorrect Set the time correctly
Caution: Time settings will be lost if the camera is not
used/remains in storage with a depleted battery over an
extended period of time
The time and date stamp on images are
unwanted
Setting was ignored Cannot be removed in retrospect
Deactivate the function as needed