Siemens AC75 User Manual
Page 113
AC75 AT Command Set
4.7 AT+IFC
s
AC75_ATC_V01.002
Page 113 of 569
10/30/06
Confidential / Released
Notes
• When using XON/XOFF flow control (
=1,x or
=3,x) in data mode,
should not be used
while the data transmission is paused with XOFF. Before entering the command mode with
the paused
transmission should be resumed using the XON character.
• For compatibility reasons, the
command can be used in Multiplex mode, though the settings will not
take effect. However, be aware that whenever you use the
write command in Multiplex mode and
then save the current configuration to the user profile with
, the changed
setting will become
active after restart.
• The two commands
and
influence each other, i.e. settings made with
apply to
and, vice versa,
setting.