Siemens AC75 - Manual (Page 257)

AC75 AT Command Set
10.1 AT^SICS
s
AC75_ATC_V01.002 Page 257 of 569 10/30/06
Confidential / Released
Parameter Description
0...5 Internet connection profile identifier.
The
<conProfileId>
identifies all parameters of a connection profile, and,
when a service profile is created with
AT^SISS
the
<conProfileId>
needs
to be set as "conId" value of the
AT^SISS
parameter
<srvParmTag>
.
Internet connection parameter.
“conType“
Type of Internet connection.
For supported values of
<conParmValue>
refer to
<conParmValue-con-
Type>
.
“alphabet“ Selects the character set for input and output of string parameters within a pro-
file.
The selected value is bound to the specific profile. This means that different
profiles may use different alphabets. Unlike other parameters the alphabet can
be changed no matter whether the
<conParmTag>
value "conType" has been
set.
For supported values of
<conParmValue>
refer to
<conParmValue-
alphabet>
.
“user“ User name string: maximum 32 characters (where "" is default).
“passwd“ Password string: maximum 32 characters (where ***** is default).
If
<conParmValue-authMode>
is "MsChapV1" then the maximum password
length is 16 characters.
“apn“ Access point name string value: maximum 100 characters (where "" is default).
“inactTO“ Inactivity timeout value in seconds: 0 ... 2 16 -1, default = 20
Number of seconds the bearer remains open although the service no longer
needs the bearer connection.
Do not set the timeout value below 3 sec. This may result in problems when
using the
<eodFlag>
(set in the last
AT^SISW
command to terminate an
upload data stream).
The value -1 indicates that, after opening the bearer with
AT^SICO
, the inac-
tivity timeout is currently disabled. Closing the bearer with
AT^SICC
restores
the previously set "inactTO" value of the concerned connection profile.
“calledNum“ Called BCD number.
“dataRate“ Data rate.
For supported values of
<conParmValue>
refer to
<conParmValue-dat-
aRate>
.
“dataType“ Data call type.
For supported values of
<conParmValue>
refer to
<conParmValue-
dataType>
.
Write Command
AT^SICS= <conProfileId>
,
<conParmTag>
,
<conParmValue>
Response(s)
OK
ERROR
+CME ERROR: <err>
PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
4
Last
- + + + + + + - + -
<conProfileId>
(num)
<conParmTag>
(str)