Siemens AC75 - Manual (Page 62)

AC75 AT Command Set
2.14 AT^SCFG
s
AC75_ATC_V01.002 Page 62 of 569 10/30/06
Confidential / Released
Unsolicited Result Codes
URC 1
^SCFG: "AutoExec", <AutoExecState> , <AutoExecType> , <AutoExecIndex> ,
<AutoExecMode> , <AutoExecATC>
If the event specified with
<AutoExecType>
occurs and the related AT command line is executed this URC
is issued.
URC 2
^SYSSTART AIRPLANE MODE
This URC is issued each time the Airplane mode is activated, no matter whether Airplane mode is set with
parameter
<map>
="on" or
<mapos>
="on". The URC notifies the user that only the AT commands supported
in Airplane mode are accessible. After leaving the Airplane mode the URC "
^SYSSTART
" indicates that the
ME has returned to Normal mode and the full set of AT commands is accessible again.
Write Command
Userware debug interface:
AT^SCFG=
"Userware/DebugInterface"[,
<udbgif1>
,
<udbgif2>
[,
<udbgif3>
]]
Response(s)
^SCFG:
"Userware/DebugInterface",
<udbgif1>
,
<udbgif2>
,
<udbgif3>
OK
ERROR
+CME ERROR
Write Command
Userware mode:
AT^SCFG=
"Userware/Mode"[,
<umode>
,
<uurl>
,
<uport>
]
Response(s)
^SCFG:
"Userware/Mode",
<umode>
,
<uurl>
,
<uport>
OK
ERROR
+CME ERROR
Write Command
Standard output of userware
AT^SCFG=
"Userware/Stdout"[,
<if>
[,
<intvalue>
][,
<filename>
][,
<logmode>
]]
Response(s)
^SCFG:
"Stdout" ,
<if>
[,
<intvalue>
[,
<filename>
[,
<logmode>
]]]
OK
ERROR
+CME ERROR
PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
4
Last
- + + + + + + ± ± -