Siemens AC75 - Manual (Page 298)

AC75 AT Command Set
10.14 Examples of how to Configure and Use Internet Service Profiles
s
AC75_ATC_V01.002 Page 298 of 569 10/30/06
Confidential / Released
10.14 Examples of how to Configure and Use Internet Service Profiles
Below you can find selective examples of how to configure and use Internet service profiles. To visualize the dif-
ference between URC mode and polling mode the operation of services (after opening with
AT^SISO
) is
explained in separate examples for either mode.
10.14.1 Selecting URC Mode or Polling Mode
To enable or disable the presentation of URCs for the Internet services use the
AT^SCFG
command, type "TcpIp/
WithURCs" and select "on" or "off" for parameter
<tcpWithUrc>
.
10.14.2 Configuring Socket Listener
The example assumes that a connection profile has been created as explained in Section 10.1.1 or Section
10.1.2 . Keep in mind that if the host is configured as listener another service profile must be left free to be dynam-
ically assigned as Server when the listener receives a connection request from a remote client.
Configure the service profile 4 for use as Socket listener:
Open the Socket service and query the IP address dynamically assigned to the Socket listener:
at^scfg=tcp/withurcs
Query the current setting.
^SCFG: "Tcp/WithURCs","on"
URC mode is enabled (delivery detault).
OK
at^scfg=tcp/withurcs,off
Select polling mode (by switching off URC mode).
^SCFG: "Tcp/WithURCs","off"
Polling mode is accepted.
OK
at^siss=4,srvType,socket
Select service type Socket.
OK
at^siss=4,conId,0
Select connection profile 0.
OK
at^siss=4,address,"socktcp://lis-
tener:65534"
The host specifies its local port 65534 to be used for
the Socket listener service. The local IP address will
be dynamically assigned when the service is opened
with
AT^SISO
.
OK
at^siso=4
Open the Socket service.
OK
at^siso?
Query the current status of services. All service pro-
files are unused, except for service profile 4 which is
running in listener mode, where
<srvState>
=3 (lis-
tening) and
<socketState>
=3 (LISTENER). The
response also indicates the IP address dynamically
assigned to the listener.
^SISO: 0, ""
^SISO: 1, ""
^SISO: 2, ""
^SISO: 3, ""
^SISO: 4, "Socket","3","3","0","0","10.10.0.187:65534","0.0.0.0:0"
^SISO: 6, ""
^SISO: 7, ""
^SISO: 8, ""
^SISO: 9, ""
OK