Siemens AC75 - Manual (Page 303)

AC75 AT Command Set
10.14 Examples of how to Configure and Use Internet Service Profiles
s
AC75_ATC_V01.002 Page 303 of 569 10/30/06
Confidential / Released
10.14.10 Sending Email (Polling Mode)
This example uses the service profile described in Section 10.14.8 .
^SISW: 9, 1
The "
^SISW
" URC indicates that email data can be
transferred.
at^sisw=9,87
The email to be sent has 87 bytes.
^SISW: 9,87,87
The write command response confirms that 87 bytes
are available for transmission.
Good Morning everyone, we are delighted to
announce our next meeting on Sunday morning.
Write the message text.
OK
at^sisw=9,0,1
Set the
<eodFlag>
to mark the end of the email
body.
^SISW: 9,0,0
The
<eodFlag>
is accepted by the service.
^SISW: 9,2
The "
^SISW
" URC confirms that all data is sent suc-
cessfully.
at^sisi=9
Check the connection state of the service profile 9.
^SISI: 9,6,0,87,0,0
The command response confirms that the SMTP
service is in state "6" (Down) and that 87 bytes have
been transferred.
at^sisc=9
Close the service.
OK
at^siso=9
Open the service, i.e. start to send the email.
OK
at^sisw=9,10
Try to write 10 bytes.
^SISW: 9, 10, 0
The service response indicates that 10 bytes can be
written.
Hallo Tom!
Write 10 bytes.
OK
at^sisw=9,10
Try to write 10 bytes.
^SISW: 9, 0, 0
The service response indicates that the service
refuses to accept any data at the moment.
OK
at^sisw0=9,12
Try to write 12 bytes.
^SISW: 9, 12, 0
The service response indicates that 12 bytes can be
written.
Bye Bye Tom!
Write 12 bytes.
OK
at^sisw=9,0,1
Set the
<eodFlag>
to mark the end of the email
body.
^SISW: 9,0,0
The
<eodFlag>
is accepted by the service.
OK
at^sisi=9
Check the connection state of service profile 9.
^SISI: 9,5,0,22,0,0
The command response confirms that the SMTP
service is in state "5" (Closing) and that 22 bytes
have been written.
OK
at^sisi=9
Check the connection state of service profile 9.
^SISI: 9,6,0,22,0,0
The command response confirms that the SMTP
service is in state "6" (Down) and that 22 bytes have
been written.
OK
at^sise=9
Check error status of service profile 9.
^SISE: 9,0
The command response confirms that no error
occurred.
OK