Siemens AC75 - Manual (Page 54)

AC75 AT Command Set
2.13 AT+CSCS
s
AC75_ATC_V01.002 Page 54 of 569 10/30/06
Confidential / Released
2.13 AT+CSCS Select TE character set
The
AT+CSCS
write command informs the TA which character set
<chset>
is used by the TE. This enables the
TA to convert character strings correctly between TE and ME character sets. See also Section 1.5 , Supported
character sets .
Note that when the TA-TE interface is set to 8-bit operation and the used TE alphabet is 7-bit, the highest bit will
be set to zero.
Syntax
Parameter Description
“GSM“ (&F)(P) GSM default alphabet (GSM 03.38 subclause 6.2.1);
Note: This setting may cause software flow control problems since the codes
used to stop and resume data flow (XOFF = decimal 19, XON = decimal 17)
are interpreted as normal characters.
“UCS2“ 16-bit universal multiple-octet coded character set (ISO/IEC10646 [32]); UCS2
character strings are converted to hexadecimal numbers from 0000 to FFFF;
e.g. "004100620063" equals three 16-bit characters with decimal values 65, 98
and 99.
Test Command
AT+CSCS=?
Response(s)
+CSCS:
(list of supported
<chset>
s)
OK
Read Command
AT+CSCS?
Response(s)
+CSCS: <chset>
OK
Write Command
AT+CSCS=
[
<chset>
]
Response(s)
OK
Reference(s) PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
4
Last
GSM 07.07, GSM 11.11 - + + + + + + - + -
<chset>
(str)