Siemens AC75 - Manual (Page 374)

AC75 AT Command Set
13.8 AT+CMGW
s
AC75_ATC_V01.002 Page 374 of 569 10/30/06
Confidential / Released
13.8 AT+CMGW Write Short Messages to Memory
The execute and write commands transmit a short message (either SMS-DELIVER or SMS-SUBMIT) from TE
to memory storage
<mem2>
. Memory location
<index>
of the stored message is returned. Message status will
be set to 'stored unsent' unless otherwise given in parameter
<stat>
.
After invoking the execute or write command wait for the prompt ">" and then start to write the message. To save
the message simply enter
<CTRL-Z>
. After the prompt a timer will be started to observe the input.
To abort writing use
<ESC>
. Abortion is acknowledged with "OK", though the message will not be saved.
Syntax
Notes
• If writing fails, for example, if a message is too long, the result code depends on the current setting of the
AT^SM20
command:
If the
AT^SM20 <CmgwMode>
=1 (factory default) any failure to send a message is responded with "OK". Users
should be aware, that despite the "OK" response, the message will not be written to the selected SMS stor-
age.
If the
AT^SM20 <CmgwMode>
equals 0 any failure to write a message is responded with "ERROR".
Test Command
AT+CMGW=?
Response(s)
OK
Exec Command
If text mode (see
AT+CMGF
=1):
AT+CMGW
Response(s)
<CR>
Text can be entered.
<CTRL-Z>
/
<ESC>
+CMGW: <index>
OK
If writing fails
ERROR
+CMS ERROR
Write Command
If text mode (see
AT+CMGF
=1):
AT+CMGW= <oa>
/
<da>
[, [
<tooa>
/
<toda>
][,
<stat>
]]
<CR>
Text can be entered.
<CTRL-Z>
/
<ESC>
Response(s)
+CMGW: <index>
OK
If writing fails see notes below.
Write Command
If PDU mode (see
AT+CMGF
=0):
AT+CMGW= <length>
[,
<stat>
]
<CR>
PDU can be entered.
<CTRL-Z>
/
<ESC>
Response(s)
+CMGW: <index>
OK
If writing fails see notes below.
Reference(s) PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
4
Last
GSM 07.05 + + + + + + + - + -