Siemens AC75 - Manual (Page 77)

AC75 AT Command Set
2.14 AT^SCFG
s
AC75_ATC_V01.002 Page 77 of 569 10/30/06
Confidential / Released
• Parameters "GPRS/ATS0/withAttach" (
<gs0aa>
) and "GPRS/RingOnIncomingData" (
<groid>
) are avail-
able only for modules supporting GPRS.
Examples
EXAMPLE 1
Usage of "AutoExec":
Enable sending of a short message (SMS) on next DTR activation (OFF-ON transition). Sent SMS is
assumed to be stored at first location of storage selected with
AT+CPMS
and
AT^SSMSS
, i.e. SMS may be
sent either from SIM or ME storage.
Also refer to
AT+CMSS
and
AT+CMGW
. Since SMS transmission and ongoing calls are possible at the same
time there is no need to wait until all calls have ended (
<AutoExecMode>
=0).
If a DTR activation has occured the ME issues the URC "
^SCFG:
" followed by the response of the executed
command; the message reference in this case:
EXAMPLE 2
Usage of "AutoExec":
Configure AC75 to perform a reset every 10 hours. The execution of the reset command shall be deferred
until after any calls have ended.
For details regarding software controlled power down refer to
AT+CFUN
and
AT^SMSO
.
After ten hours:
EXAMPLE 3
Usage of "AutoExec":
Switch off the ME after three minutes without restarting it.
For details regarding software controlled power down refer to
AT+CFUN
and
AT^SMSO
.
Please keep in mind that if the GSM alphabet is enabled special characters within the executed AT command
AT+CMGF=1
Enable SMS text mode.
OK
AT+CNMI=1,1
Enable "+CMTI:" URC to be indicated when a short
message is received.
OK
AT+CMGD=1
Delete first SMS location.
OK
AT+CMGW="01522400045",145
Start writing a short message.
>Test-SMS to be sent from storage!
Enter the text of the message. Finish with CTRL-Z.
+CMGW: 1
Confirms that message is stored to first location.
OK
AT^SCFG="AutoExec",1,0,0,0,"AT+CMSS=1"
Enable execution on next DTR activation.
^SCFG: "AutoExec","1","0","0","0","at+cmss=1"
^SCFG: "AutoExec","0","1","0","0","","000:00:00","000:00:00"
^SCFG: "AutoExec","0","1","1","0","","000:00:00","000:00:00"
^SCFG: "AutoExec","0","1","2","0","","000:00:00","000:00:00"
OK
^SCFG:"AutoExec",0,0,1,0,"AT+CMSS=1"
OK
Confirms that AT+CMSS=1 has been issued.
+CMSS: 16
AT^SCFG="AutoExec",1,1,2,5,"AT+CFUN=0,1","010:00:00"
...
OK
^SCFG:"AutoExec",1,1,2,5,"AT+CFUN=0,1"
OK
Confirms that AT+CFUN=0,1 has been issued.
SYSSTART
AC75 has restarted. Remember that the
"^SYSSTART" URC will not appear if autobauding is
enabled.