Of urc, Slcc, Will be iss – Siemens AC75 User Manual
Page 183: Urcs, Dicator, Ac75 at command set
AC75 AT Command Set
7.22 AT^SLCC
s
AC75_ATC_V01.002
Page 183 of 569
10/30/06
Confidential / Released
Unsolicited Result Code
Unsolicited Call Status information
if the list of current calls is empty:
^SLCC:
if one or more calls are currently in the list:
^SLCC:
[,
]]
[^SLCC:
,
,
]]]
[... ]
^SLCC:
URC "
" displays the list of current calls as displayed with the execute command
. The list is dis-
played in the state it has at the time of display, not in the state it had when the signal was generated.
The URC's occurrence indicates call status changes for any of the calls in the list of current calls.
Please refer to
and
for further information about the configuration of
this URC.
Event reporting can be enabled separately for each interface. Interface settings are saved with
and can be
displayed with
. Additionally, The URC presentation mode for the interface must be configured with
setting
, Indicator "
" will be issued (if configured with write
command
and
)
• when a state transition ends in state "active" or in state "unknown" (if
setting
="restricted")
• when any state transition (including transitions beginning or ending in state "unknown") occurs in the list of
active calls, or when a traffic channel is established (if
setting
="verbose").
If multiple displays of identical list configurations occur, this happens because of short intermediate states of the
list, that have already been overridden by new transitions and states. Thus, it is guaranteed that the configuration
displayed is always the current configuration at the time of the last display.
The list of active calls displayed with this URC will always be terminated with an empty line preceded by prefix
"^SLCC: ", in order to indicate the end of the list.
Command Description
The read command returns an indication whether event reporting is active for the current interface.
The exec command returns a list of current calls of ME. If command is successful, but no calls are available, no
information response is sent to TE.
Use the write command to activate or deactivate event reporting for URC "
". Event reporting can be
enabled separately for each interface. Interface settings are saved with
and can be displayed with
Parameter Description
Call identification number as described in GSM02.30 subclause 4.5.5.1; this number can be used in
command operations.
[0]
(&F)
Presentation of URC "
" disabled
1
Presentation of URC "
" enabled
0
Mobile originated call (MOC)
1
Mobile terminated call (MTC)
<idx>
(num)
<n>
(num)(&W)(&V)
<dir>
(num)