Siemens AC75 - Manual (Page 332)

AC75 AT Command Set
11.11 AT+CGQREQ
s
AC75_ATC_V01.002 Page 332 of 569 10/30/06
Confidential / Released
11.11 AT+CGQREQ Quality of Service Profile (Requested)
Syntax
Command Description
The test command returns values supported as a compound value. If the MT supports several PDP types, the
parameter value ranges for each PDP type are returned on a separate line.
The read command returns the current settings for each defined context.
This command allows the TE to specify a Quality of Service Profile that is used when the MT sends an Activate
PDP Context Request message to the network.
The set command specifies a profile for the context identified by the (local) context identification parameter,
<cid>
.
A special form of the set command, +CGQREQ=
<cid>
causes the requested profile for context number
<cid>
to become undefined.
AT&F
and
ATZ
will undefine the QoS profiles of every context which is not active or not online.
Parameter Description
Parameter specifies a particular PDP context definition. The parameter is local to the TE-MT interface and is
used in other PDP context-related commands.
1...2
Precedence class
[0]
network subscribed value
1 High Priority
Service commitments shall be maintained ahead of precedence classes 2 and
3
Test Command
AT+CGQREQ=?
Response(s)
+CGQREQ: <PDP_type>
, (list of supported
<precedence>
s), (list of supported
<delay>
s), (list of
supported
<reliability>
s), (list of supported
<peak>
s), (list of supported
<mean>
s)
OK
Read Command
AT+CGQREQ?
Response(s)
[+CGQREQ:
<cid>
,
<precedence>
,
<delay>
,
<reliability>
,
<peak>
,
<mean>
]
[+CGQREQ: ...]
Write Command
AT+CGQREQ=
[
<cid>
[,
<precedence>
[,
<delay>
[,
<reliability>
[,
<peak>
[,
<mean>
]]]]]]
Response(s)
OK
ERROR
+CME ERROR
Reference(s) PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
4
Last
GSM 07.07 + + + + + + + - + -
<cid>
(num)
<precedence>
(num)