Siemens AC75 - Manual (Page 73)

AC75 AT Command Set
2.14 AT^SCFG
s
AC75_ATC_V01.002 Page 73 of 569 10/30/06
Confidential / Released
CIEV Call Status Indication
This parameter can be used to control the behaviour of URC "
+CIEV
: call". See also
AT+CIND
,
AT+CMER
and
Section 7.1 , Call Status Information .
Parameter is global for all interfaces and will not be reset by
AT&F
.
“restricted“ (P) URC "
+CIEV
: call" will be issued only when a Call Status transition ends in
state "active" or "unknown" (see Section 7.1 , Call Status Information ) for a call
in the list of active calls.
“verbose“ URC "
+CIEV
: call" will be issued when any state transition (including transi-
tions beginning or ending in state "unknown") occurs in the list of active calls,
or when a traffic channel is established.
SLCC Call Status Indication
This parameter can be used to control the behaviour of URC "
^SLCC
". See also
AT^SLCC
and Section 7.1 , Call
Status Information .
Parameter is global for all interfaces and will not be reset by
AT&F
.
“restricted“ URC "
^SLCC
" will be issued only when a Call Status transition ends in state
"active" or "unknown" (see Section 7.1 , Call Status Information ) for a call in the
list of active calls
“verbose“ (P) URC "
^SLCC
" will be issued when any state transition (including transitions
beginning or ending in state "unknown") occurs in the list of active calls, or
when a traffic channel is established.
URC RING line
This parameter can be used to control the behaviour of the RING line to indicate URCs (both for idle interfaces
and, if configured by the parameter "URC/Datamode/Ringline", if link is reserved) and, if configured, the indicator
for incoming IP packets (see parameter "GPRS/RingOnIncomingData" (
<groid>
).
Parameter is local for the interface, volatile and will not be reset by
AT&F
.
“off“ URC is not indicated by RING.
“local“ (P) URC will be indicated by an activated RING line of the interface on which the
URC appears
“asc0“ URC is indicated by an activated RING0 line.
URC Datamode RING line
This parameter specifies whether RING or BREAK is used for the signaling of URCs when the TA-TE link is
reserved (e.g. during circuit-switched data calls, fax connections, in GPRS data mode or during the execution
of an AT command).
Parameter is global for all interfaces, volatile and will not be reset by
AT&F
.
“off“ (P) URC will be indicated by BREAK
“on“ URC is indicated by an active RING line for a time which is configured by the
parameter "URC/Ringline/ActiveTime" (
<urat>
). The RING line which will be
used, can be configured by the parameter "URC/Ringline" (
<uri>
).
<succ>
(str)(+CSCS)
<sucs>
(str)(+CSCS)
<uri>
(str)(+CSCS)
<udri>
(str)(+CSCS)