Siemens AC75 - Manual (Page 519)

AC75 AT Command Set
20.9 AT^SSCNT
s
AC75_ATC_V01.002 Page 519 of 569 10/30/06
Confidential / Released
20.9 AT^SSCNT Start and Stop Pulse Counter
The
AT^SSCNT
write command serves to read, start, restart and stop the pulse counter.
Syntax
Unsolicited Result Code
^SSCNT: <pulse>
The URC applies only to the Start-Stop mode set with
AT^SCCNT
, parameter
<mode>
=0. It is delivered once the
pulse counter result was requested with
<action>
=2 or the pulse counter was stopped with
<action>
=3. The
URC indicates the number of pulses counted.
Parameter Description
This parameter can only be used after configuring the pulse counter with
AT^SCCNT
. The
<action>
types 0, 1
and 2 apply only to the Start-Stop counter mode set with
AT^SCCNT
.
0 Reset and start pulse counter from 0.
1 Restart pulse counter and continue counting from the
<pulse>
value of the
last run.
2 Read out current
<pulse>
value.
Test Command
AT^SSCNT=?
Response(s)
^SSCNT:
(list of supported
<action>
s)
OK
Read Command
AT^SSCNT?
Response(s)
^SSCNT: <action>
OK
If an error occurs:
ERROR
+CME ERROR: <err>
Write Command
AT^SSCNT= <action>
Response(s)
If
<action>
=0 or 1:
OK
If
<action>
=2 or 3:
OK
" ^SSCNT " URC with parameter <pulse>
If an error occurs:
ERROR
+CME ERROR: <err>
Reference(s) PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
4
Last
SIEMENS - + + + + + + - + -
<action>
(num)