Siemens AC75 - Manual (Page 353)

AC75 AT Command Set
12.2 AT+FCLASS
s
AC75_ATC_V01.002 Page 353 of 569 10/30/06
Confidential / Released
12.2 AT+FCLASS Fax: Select, read or test service class
AT+FCLASS
sets the ME to a particular mode of operation (data, fax). This allows the ME to process information
in a manner suitable for that type of information.
Syntax
Parameter Description
0 (&F) Data (e.g. EIA/TIA-602 or ITU V.250)
1 Fax class 1 (EIA/TIA-578-A, Service Class 1)
Notes
• Using Error Correcting Mode (ECM) when sending FAXes over GSM should be avoided.
• If
<n>
is set to 1, all incoming calls will be answered as fax calls when
ATA
is issued on multiplexer channel
1 resp. ASC0. For calls explicitly signaled as voice or data calls, this procedure will fail with result code "NO
CARRIER", but the incoming call will continue to ring.
It is possible to change the setting of
<n>
to 0 while the call is ringing, and accept the call afterwards with
ATA
.
Test Command
AT+FCLASS=?
Response(s)
(list of supported
<n>
s)
OK
Read Command
AT+FCLASS?
Response(s)
<n>
OK
Write Command
AT+FCLASS= <n>
Response(s)
OK
Reference(s) PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
4
Last
EIA/TIA-592-A - + - + + - - - + -
<n>
(num)(&W)(&V)