Siemens AC75 - Manual (Page 317)

AC75 AT Command Set
11.6 AT+CGDCONT
s
AC75_ATC_V01.002 Page 317 of 569 10/30/06
Confidential / Released
11.6 AT+CGDCONT Define PDP Context
Syntax
Command Description
The test command returns supported values as a compound value.
The read command returns the current settings for each defined PDP context.
The write command specifies the parameters for a PDP context identified by the context identifier
<cid>
. The
number of contexts that may be in a defined state at the same time is given by the range returned by the test
command. A special form of the write command (
AT+CGDCONT
=
<cid>
) causes the values for context
<cid>
to
become undefined.
Parameter Description
PDP Context Identifier
Parameter specifies a particular PDP context definition. The parameter is local to the TE-MT interface and is
used in other PDP context-related commands.
1...2
Packet Data Protocol type
Specifies the type of the packet data protocol.
“IP“
Internet Protocol (IETF STD 5)
Test Command
AT+CGDCONT=?
Response(s)
+CGDCONT:
(range of supported
<cid>
s),
<PDP_type>
, , , (list of supported
<d_comp>
s), (list of supported
<h_comp>
s)
OK
ERROR
+CME ERROR
Read Command
AT+CGDCONT?
Response(s)
[+CGDCONT:
<cid>
,
<PDP_type>
,
<APN>
,
<PDP_addr>
,
<d_comp>
,
<h_comp>
]
[+CGDCONT: ...]
OK
ERROR
+CME ERROR
Write Command
AT+CGDCONT=
[
<cid>
[,
<PDP_type>
[,
<APN>
[,
<PDP_addr>
[,
<d_comp>
[,
<h_comp>
]]]]]]
Response(s)
OK
ERROR
+CME ERROR
Reference(s) PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
4
Last
GSM 07.07 + + + + + + + - + -
<cid>
(num)
<PDP_type>
(str)