Ats0, 1) than, Ac75 at command set – Siemens AC75 User Manual
Page 170
AC75 AT Command Set
7.12 ATS0
s
AC75_ATC_V01.002
Page 170 of 569
10/30/06
Confidential / Released
7.12
ATS0 Set number of rings before automatically answering a call
Syntax
Parameter Description
000
(&F)
Automatic answer mode is disabled.
001-255
Enable automatic answering after specified number of rings.
Notes
• This command works for MT data and fax calls.
• Autoanswering of CSD data and fax calls is supported on ASC0/Mux1 only.
• If
is set to higher values, the calling party may hang up before the call is automatically answered.
• The correlation between
and
is important.
Example: Call setup may fail if ATS7=30 and ATS0=20.
• Setting is local to the interface. It is allowed to have different settings on different interfaces. In such cases
the interface 'wins', which is idle and uses the smallest
value.
• The ATS0 write command is PIN protected.
• According to
"3GPP TS 27.007 (GSM 07.07): AT command set for User Equipment (UE)"
is also used
as GPRS compatibility command to answer automatically to a network request for PDP context activation
(see Section
write command is issued with
attempt to perform a GPRS attach if not yet attached and if configured to do so (due to the setting
="GPRS/ATS0/withAttach","on").
If the automatic GPRS attach fails the ME keeps trying to attach for approx. 5 minutes, before
ends up
with "ERROR" or "+CME ERROR: unknown", though the new
value takes effect. To avoid the risk of long
response times to
in such case take care that the parameter
is off, if autoanswer
mode is not needed for GPRS or if the mobile works in non-GPRS networks.
The GPRS attach will not be performed on recalling a stored user profile with
or on powerup, even though
a value
greater than 0 was stored in the user profile with
Read Command
ATS0?
Response(s)
OK
ERROR
Write Command
ATS0=
Response(s)
OK
ERROR
Reference(s)
PIN
ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
4
Last
V.250
±
+
+
+
+
+
+
-
-
-
<n>
(num)(&W)(&V)