Siemens AC75 - Manual (Page 196)

AC75 AT Command Set
8.2 AT+COPS
s
AC75_ATC_V01.002 Page 196 of 569 10/30/06
Confidential / Released
Parameter Description
Status
0
Unknown
1 Operator available
2 Current operator
3 Operator forbidden
Operator
If test command: Operator name in long alphanumeric format and numeric format.
If read command: Operator name as per
<format>
.
If write command: Operator name in numeric format.
Parameter values 0 and 1 are stored non-volatile in the AC75.
0
(D) Automatic mode;
<oper>
field is ignored.
1 Manual operator selection
Write command requires
<oper>
in numeric format, i.e.
<format>
shall be 2.
Read command returns the current
<mode>
and the currently selected
<oper>
. If no operator is selected,
<format>
and
<oper>
are omitted.
2 Manually deregister from network and remain unregistered until
<mode>
=0 or
1 or 4 is selected.
3 Set only
<format>
(for
AT+COPS
read command).
4 Automatic / manual selection; if manual selection fails, automatic mode
(
<mode>
=0) is entered (
<oper>
field will be present).
Read Command
AT+COPS?
Response(s)
+COPS: <mode>
[,
<format>
[,
<oper>
]]
OK
ERROR
+CME ERROR: <err>
Write Command
AT+COPS= <mode>
[,
<format>
[,
<oper>
]]
Response(s)
OK
ERROR
+CME ERROR: <err>
Reference(s) PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
4
Last
GSM 07.07 ± + + + + + + - - -
<opStatus>
(num)
<oper>
(str)
<mode>
(num)(&V)