Mode, Inddescr, Indvalue – Siemens AC75 User Manual
Page 81: Value, Keyp, Supported, Disp, Cmer, Ac75 at command set
AC75 AT Command Set
3.1 AT+CMER
s
AC75_ATC_V01.002
Page 81 of 569
10/30/06
Confidential / Released
Parameter Description
0
(&F)
Discard "
" and "
1
Discard "
" and "
" URCs when TA-TE link is reserved, e.g. in
online data mode. Otherwise they are forwarded directly to the TE.
2
" and "
" URCs in the TA while TA-TE link is reserved, e.g.
in online data mode, and flush them to the TE afterwards. Otherwise they are
forwarded directly to the TE.
3
Forward "
" and "
" URCs directly to the TE. If AC75 is in online
data mode, URCs are signaled via sending BREAK and stored in a buffer.
Once it is back in command mode e.g. after
was entered, all URCs stored
in the buffer will be output.
0
(&F)
Keypad event reporting is not supported by AC75.
0
(&F)
Display event reporting is not supported by AC75.
0
(&F)
Disable indicator event reporting.
2
Enable indicator event reporting.
0
(&F)
TA buffer of URCs defined within this command is cleared when
is entered.
Name of indicator; for a list of all supported indicators please refer to
and
.
Value of indicator; for a list of all values for the supported indicators please refer to
and
.
Notes
• If the ME operates on different instances (MUX channels 1, 2, 3 or ASC0/ASC1) avoid different settings for
routing and indicating SMS. For example, if messages shall be routed directly to one instance of the TE (set
), it is not possible to activate the presentation of URCs with
on another instance. Any attempt to activate settings that conflict with existing settings on another interface,
will result in CME ERROR, or accordingly CMS ERROR.
• It is recommended that priority be given to
2 or 3. Otherwise, if
equals 1, URCs
will be discarded in case of long running AT commands or an active data connectiion.
<mode>
(num)
<keyp>
(num)
<disp>
(num)
<ind>
(num)
<bfr>
(num)
<indDescr>
(str)
<indValue>
(num)