Siemens AC75 - Manual (Page 244)

AC75 AT Command Set
9.10 AT+CLIR
s
AC75_ATC_V01.002 Page 244 of 569 10/30/06
Confidential / Released
9.10 AT+CLIR Calling Line Identification Restriction
The
AT+CLIR
command refers to the GSM supplementary service CLIR (Calling Line Identification Restriction).
Syntax
Parameter Description
Parameter shows the settings for outgoing calls:
[0]
(P) Presentation indicator is used according to the subscription of the CLIR service
1 CLIR invocation
2 CLIR suppression
Parameter shows the subscriber CLIR service status in the network:
0
CLIR not provisioned
1 CLIR provisioned in permanent mode
2 Unknown (e.g. no network, etc.)
3 CLIR temporary mode presentation restricted
4 CLIR temporary mode presentation allowed
Note
• The settings made with
AT+CLIR
=1 or
AT+CLIR
=2 are used for all outgoing calls until the ME is switched off
or
AT+CLIR
=0 is used.
Test Command
AT+CLIR=?
Response(s)
+CLIR:
(list of supported
<n>
s)
OK
Read Command
AT+CLIR?
Response(s)
+CLIR <n>
,
<m>
OK
ERROR
+CME ERROR: <err>
Write Command
AT+CLIR=
[
<n>
]
Response(s)
OK
ERROR
+CME ERROR: <err>
Reference(s) PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
4
Last
GSM 07.07 + + + + + + + - - -
<n>
(num)
<m>
(num)