Siemens AC75 - Manual (Page 513)

AC75 AT Command Set
20.4 AT^SCPORT
s
AC75_ATC_V01.002 Page 513 of 569 10/30/06
Confidential / Released
20.4 AT^SCPORT Port Configuration
With
AT^SCPORT
a group of maximum 10 pins can be configured to act as a parallel port, which can be controlled
with a single AT command. A pin can only be added once to a port, and only to a port. The first, i.e. left most
parameter, corresponds to the port's LSB.
All pins of a port must be set to the same direction (input or output). See
AT^SCPIN
.
Syntax
Parameter Description
Assigned port
Pin ID of the xth pin of this port
See
AT^SCPIN
for possible pin value.
Test Command
AT^SCPORT=?
Response(s)
OK
Write Command
AT^SCPORT= <pin_id>
1
[,
<pin_id>
2
[,
<pin_id>
3
[,
<pin_id>
4
[,
<pin_id>
5
[,
<pin_id>
6
[,
<pin_id>
7
[,
<pin_id>
8
[,
<pin_id>
9
[,
<pin_id>
10
]]]]]]]]]
Response(s)
^SCPORT: <port_id>
OK
ERROR
+CME ERROR: <err>
Reference(s) PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
4
Last
SIEMENS - + + + + + + - + -
<port_id>
(num)
<pin_id>
(num)