Siemens AC75 - Manual (Page 198)

AC75 AT Command Set
8.3 AT^SOPS
s
AC75_ATC_V01.002 Page 198 of 569 10/30/06
Confidential / Released
8.3 AT^SOPS Extended Operator Selection
AT^SOPS
queries the present status of the AC75's network registration. Since basic operator selection services
are available with
AT+COPS
this command uses the methods of the Enhanced Operator Name String (EONS)
specification while handling operator name strings. Additional EONS related information is available with
AT^SIND
.
AT^SOPS
test command lists sets of five parameters, each representing an operator present in the network.
A set consists of
1. an integer indicating the availability of the operator,
2. specification of the source of the operator name
<eonsOperator>
,
3. operator name according to EONS Table,
4. Service Provider Name from the SIM Service Table and
5. numeric format representation of the operator.
Any of the parameters may be unavailable and will then be an empty field (,,).
The list of operators comes in the following order: Home network, networks referenced in SIM and other net-
works.
After the operator list the AC75 returns lists of supported
<mode>
s and
<format>
s. These lists are delimited
from the operator list by two commas.
If the test command is used while an ongoing GPRS transfer, traffic will be interrupted for up to one minute.
Command settings are effective over all serial interfaces of the AC75.
Syntax
Parameter Description
Status
0
unknown
1 operator available
2 current operator
3 operator forbidden
Specification of the source of the operator name
<eonsOperator>
. Details of EONS-supplied operator name
types are available at
AT^SIND
.
Test Command
AT^SOPS=?
Response(s)
^SOPS:
[list of present operator(
<opStatus>
,
<eonsType>
,
<eonsOperator>
,
<servProvider>
,
<opName>
)s ], , (list of supported
<mode>
)s, (list of supported
<format>
)s
OK
ERROR
+CME ERROR: <err>
Reference(s) PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
4
Last
SIEMENS + + + + + + + - + -
<opStatus>
(num)
<eonsType>
(num)