Siemens AC75 - Manual (Page 258)

AC75 AT Command Set
10.1 AT^SICS
s
AC75_ATC_V01.002 Page 258 of 569 10/30/06
Confidential / Released
“authMode“ Authentication mode.
For supported values of
<conParmValue>
refer to
<conParmValue-auth-
Mode>
.
“fnur“ Fixed Network User Rate.
For supported values of
<conParmValue>
refer to
<conParmValue-fnur>
.
“dns1“ Primary DNS server address (IP address in dotted-four-byte format).
This value determines whether to use the DNS server addresses dynamically
assigned by the network or a specific DNS server address given by the user.
"dns1" = "0.0.0.0" (default) means that the CSD or GPRS connection profile
uses dynamic DNS assignment. Any other address means that the Primary
DNS is manually set.
The default value applies automatically if no other address is set. Note that the
AT^SICS
read command only returns a manually configured IP address, while
the value "0.0.0.0" is not indicated at all, no matter whether assumed by default
or explicitly specified.
See also note below.
“dns2“ Secondary DNS server address (IP address in dotted-four-byte format).
If "dns1" = "0.0.0.0" this setting will be ignored. Otherwise this value can be
used to manually configure an alternate server for the DNS1.
If "dns1" is not equal "0.0.0.0" and no "dns2" address is given, then
"dns2"="0.0.0.0" will be assumed automatically. The
AT^SICS
read command
only returns a manually configured IP address, while the value "0.0.0.0" is not
indicated at all, no matter whether assumed by default or explicitly specified.
Parameter value; type and supported content depend on related
<conParmTag>
.
Supported connection type values in
<conParmValue>
for
<conParmTag>
value "conType".
“CSD“ Circuit-switched data call.
“GPRS0“ GPRS connection.
Settings of GPRS related commands are not used, e.g.
AT+CGDCONT
. When a
service based on a GPRS connection profile is started after entering
AT^SISO
AC75 automatically tries to attach to the GPRS. Yet, the only exception is
AT+CGATT
which can be used any time to detach from the GPRS and, and thus
disconnect the bearer opened with
AT^SISO
.
“none“ Clears the connection profile.
Character set selectable with
<conParmValue>
for
<conParmTag>
value "alphabet".
[“0“] Character set determined with
AT+CSCS
applies.
“1“ International Reference Alphabet (IRA, seven bit ASCII) applies.
Supported data rate values in
<conParmValue>
for
<conParmTag>
value "dataRate".
“0“ 14.4 KBaud
[“1“] 9.6 KBaud
<conParmValue>
(str)
<conParmValue-conType>
(str)
<conParmValue-alphabet>
(str)
<conParmValue-dataRate>
(str)