Siemens AC75 - Manual (Page 462)

AC75 AT Command Set
18.8 AT^SAIC
s
AC75_ATC_V01.002 Page 462 of 569 10/30/06
Confidential / Released
18.8 AT^SAIC Audio Interface Configuration
AT^SAIC
configures the interface connections of the active audio mode. The write command is usable in audio
modes 2 to 6 only.
If
AT^SNFS
=1, any attempt to use
AT^SAIC
write command is rejected with error response. This is because all
default parameters in audio mode 1 are determined for type approval and are not adjustable.
To allocate a specific audio mode to one of the audio interfaces, first select the audio mode with
AT^SNFS
and
then choose the interface using
AT^SAIC
.
Syntax
Parameter Description
Input and output selection
1
Digital input and output
2 Analog input and output
Microphone selection
1
Microphone 1
2 Microphone 2
Select differential earpiece amplifier
1
Selects the earpiece amplifier 1
Test Command
AT^SAIC=?
Response(s)
^SAIC:
(list of supported
<io>
s), (list of supported
<mic>
s), (list of supported
<ep>
s), (list of
supported
<clock>
s), (list of supported
<mode>
s), (list of supported
<frame_mode>
s)
OK
Read Command
AT^SAIC?
Response(s)
^SAIC: <io>
,
<mic>
,
<ep>
,
<clock>
,
<mode>
,
<frame_mode>
OK
Write Command
AT^SAIC= <io>
[,
<mic>
[,
<ep>
][,
<clock>
,
<mode>
,
<frame_mode>
]]
Response(s)
OK
ERROR
+CME ERROR: operation not allowed
Reference(s) PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
4
Last
SIEMENS - + + + + + + - + -
<io>
(num)(^SNFW)
<mic>
(num)(^SNFW)
<ep>
(num)(^SNFW)