Siemens AC75 - Manual (Page 511)

AC75 AT Command Set
20.3 AT^SCPOL
s
AC75_ATC_V01.002 Page 511 of 569 10/30/06
Confidential / Released
20.3 AT^SCPOL Polling Configuration
The
AT^SCPOL
write command serves to start and stop polling a pin or port specified with
<io_id>
. The pin or
port must already be configured via
AT^SCPIN
or
AT^SCPORT
. Polling is only applicable to input pins.
After polling has been activated on a specified pin or port, all new values related to this pin or port will be reported
via the "
^SCPOL
" URC.
Syntax
Unsolicited Result Code
^SCPOL: <io_id> , <value>
Parameter Description
0 Suppress polling
1 Activate polling
This can be either a
<pin_id>
already configured or a
<port_id>
already opened.
New value on this
<io_id>
.
0 Low for
<pin_id>
1 High for
<pin_id>
0...1023 For
<port_id>
Test Command
AT^SCPOL=?
Response(s)
^SCPOL:
(list of supported
<mode>
s), (list of supported
<io_id>
s)
OK
Write Command
AT^SCPOL= <mode>
,
<io_id>
Response(s)
OK
ERROR
+CME ERROR: <err>
Reference(s) PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
4
Last
SIEMENS - + + + + + + - + -
<mode>
(num)
<io_id>
(num)
<value>
(num)