Siemens AC75 - Manual (Page 425)

AC75 AT Command Set
15.2 AT^SRSM
s
AC75_ATC_V01.002 Page 425 of 569 10/30/06
Confidential / Released
15.2.1 SAP Request Message Parameters
The table below shows all SAP request message parameters sent
• when an "
^SRSM
" URC is issued by an ME acting as SAP client
• and then the
AT^SRSM
write command is used to transfer data to the SAP server.
SAP Request Message Parameter Mapping:
15.2.2 SAP Response Message Parameters
The table below shows all SAP response and indication message parameters sent when
• an "
^SRSM
" URC is issued by an ME acting as SAP server
• and then the
AT^SRSM
write command is used to transfer data to the SAP client.
SAP Response Message Parameter Mapping:
Id SAP Message Name SAP parameter mapping to
AT^SRSA
parame-
ters
<RsaMsgId>
[,
<RsaMsgData>
[,
<RsaMs-
gLen>
[,
<RsaMsgRc>
]]]
0 CONNECT_REQ 0,,
<MaxMsgSize>
2 DISCONNECT_REQ 2
5 TRANSFER_APDU_REQ 5,
<CmdApdu>
,
<CmdApduLen>
7 TRANSFER_ATR_REQ 7
9 POWER_SIM_OFF_REQ 9
11 POWER_SIM_ON_REQ 11
13 RESET_SIM_REQ 13
15 TRANSFER_CARD_READER _STATUS_REQ 15
19 SET_TRANSPORT_PROTOCOL_REQ 19,
<TransportProtocol>
Id SAP Message Name SAP parameter mapping to
AT^SRSA
parame-
ters
<RsaMsgId>
[,
<RsaMsgData>
[,
<RsaMs-
gLen>
[,
<RsaMsgRc>
]]]
1 CONNECT_RESP 1,,
<MaxMsgSize>
,
<ConnStatus>
3 DISCONNECT_RESP 3
4 DISCONNECT_IND 4,,,
<DiscType>
6 TRANSFER_APDU_RESP 6,
<RspApdu>
,
<RspApduLen>
,
<ResCode>
8 TRANSFER_ATR_RESP 8,
<ATR>
,
<AtrLen>
,
<ResCode>
10 POWER_SIM_OFF_RESP 10,,,
<ResCode>
12 POWER_SIM_ON_RESP 12,,,
<ResCode>
14 RESET_SIM_RESP 14,,,
<ResCode>
16 TRANSFER_CARD_READER
_STATUS_RESP
16,,
<CardRdStatus>
,
<ResCode>
17 STATUS_IND 17,,,
<StatusChange>
18 ERROR_RESP 18
20 SET_TRANSPORT_PROTOCOL_RESP 20,,,
<ResCode>